Caught in a Cold Shower – Factors Why Your Hot Water May Not Last
Thursday, March 31st, 2011Have you started a nice, hot shower only to receive an arctic blast half way through? If your water never really turns hot, chances are your hot water heater requirements need time to reheat the water, particularly when you have been doing other things like washing clothes or running the dishwasher. However, if that cold shower occurs in the midst of a hot shower, you may have some problems with the hot water heater or plumbing. Consider these choices prior to you hiring a Brisbane Plumber:
1. Diagnosing a possible water heater issue – You will want to go throughout your home, testing the hot water fixtures to see whether or not your cold shower was an isolated incident or is typical throughout the entire home. If you’re not getting any hot water, your water heater will be the likely culprit.
First, check the temperature setting on your hot water heater. If all is correct, the next factor to consider is whether or not a fuse has been blown or tripped in the event you rely on electricity to heat your water. A fuse can be effortlessly replaced. When you have gas, check to see if the pilot light went out. If so, you are able to easily relight it, following the directions within the manufacturer’s manual.
If fixing the temperature setting, fuse or pilot light doesn’t fix your problem, chances are you might have many different other problems such as a defective thermocouple, flue obstructions, sediment buildup on the heating element, or even a defective temperature control.
2. When it’s an isolated shower issue – If the other fixtures in your home produce hot water and stays hot for a length of time, your shower is problem. You will find numerous problems why your shower loses hot water. If you have old galvanized steel pipes, they might be corroded and require replacing. Also, you need to check the shut-off valve for the hot water to your shower. If it is closed or partially closed, open it and test the shower for hot water. Nevertheless, in the event you only receive warm water or start obtaining cold water, you might have a shower valve problem and need to call a Plumber Brisbane.
3. Diagnosing a shower valve problem – Occasionally, shower valves become worn down with time, the rubber parts disintegrating or swelling with age. When this happens, the rubber parts block the path for flowing water. This blockage generally happens with the shower valves as heat makes the rubber swell. Occasionally, the rubber parts break apart and travel to the hot water valve to the shower, making a blockage. If you feel confident about taking apart the valve, you are able to clean out the broken pieces within the hot water valve and then replace the rubber within the shower valve. Keep in mind that most shower valves are located inside the wall and may only be accessible by a hidden panel in a closet in the next room or a cabinet within the bathroom.
If you’re in the least bit hesitant about replacing a blown fuse, relighting a pilot light, replacing a hot water heater component or clearing an obstruction from the shower valve, it is best to consult having a plumbing expert. What’s much better – paying for a plumber to fix it correctly the very first time or waste cash by cause even worse plumbing problems and end up paying much more for a Plumber Brisbane?

